Configuring Digium cards with Asterisk , goautodial , vicidial , vicidialnow , freepbx
eduguru 1 Comment ) "if goautodial/vicidial/vicibox use the below dialplan in carrier or custome dialplan" exten => _9XXXXX., ) then the Dhadi driver will be by default installed, 1, 2, 3, AGI(agi://127.0.0.1:4577/call_log) exten => _9XXXXX., Configuring Digium cards with Asterisk, Configuring Digium cards with vicidial, Dial(DAHDI/g0/${EXTEN:1}, Dial(DAHDI/g0/${EXTEN}, elastix, follow the below steps type dahdi_genconf -vvvvvvv -this will auto install configure the digium card driver and conf files [root@localhost ~]# dahdi_genconf -vvvvvv Default parameters from /etc/dahdi/, freepbx, goautodial, Hangup 8a. if your using freepbx based pbx then no need to above line, How to configure the Digium PRI cards in Asterisk or vicidial or Goautodial or vicidialnow or Freepbx If you are using the precompiled iso of asteirsk software like ( trixbox, if digium card is recognised it shows output as below 0e:08.0 Ethernet controller: Digium, if not you need to install the dahdi driver manually.(installation of dahdi explained at last of this doc) steps to configure the Digium cards First you need to check whether card is in E1 or T1 mode., if T1 then it should be open. then insert the card into the server. Access your asterisk server via ssh, if your PRI line is E1 then you need close the jumper, Inc. Wildcard TE121 single-span T1/E1/J1 card (PCI-Express) (rev 11) Once the card is recognised, just you need to add g0 in the DAHDI identifier under trunk (add new dahdi trunk) 9. And the default incomming context will the from-pstn Installing the DAHDI driver a. you need to install libpri if y, pbxinaflash, putty will be good tool to connect the server remotely via ssh First you need to check whether the card is recognised by the your server type lspci this will output pci boards connected in the server, so in your dialplan you need to mention g0 8. so you need write dialplan as exten => _X., some small changes to be done to enable the channels in the asterisk go to vi /etc/asterisk/chan_dahdi.conf go to last line of the file by pressing shift+g then add this line #include dahdi-channels.c, TtoR) exten => _9XXXXX., vicibox, vicidial, vicidialnow
How to configure the Digium PRI cards in Asterisk or vicidial or Goautodial or vicidialnow or Freepbx If you
Read more